[strongSwan] Config/Install compiled strongswan

[吕迪]

Hi Andreas,

I tried the default setup, but it's still not binding to port 500. Is there
any other place I should look at?

Thanks,
Di


2017-03-07 14:36 GMT-08:00 Andreas Steffen <andreas.steffen at strongswan.org>:

> Hi,
>
> selecting the --enable-all option is not a good idea. This might
> lead to the loading of conflicting socket plugins preventing the
> charon daemon of starting up at all.
>
> Couldn't you just start with the default setup
>
>   ./configure --prefix=/usr --sysconfdir=/etc
>   make
>   sudo make install
>
> at the outset and enabling additional desired plugins later on?
>
> Regards
>
> Andreas
>
> On 07.03.2017 22:58, 吕迪 wrote:
> > Hi,
> >
> > I tried to compile and install a strongswan on my computer by doing
> >
> >> ./configure --prefix=/usr --sysconfdir=/etc --enable-all
> >> make
> >> sudo make install
> > ,
> > but the charon process is not binding to port 500 for ike when I do
> > "sudo ipsec start".
> >
> > When I run "sudo lsof -i:500 -n -P", nothing shows up.
> >
> > Please give me some help on this, anything l missed or I should
> configure?
> >
> > Thanks,
> > Di
>
> ======================================================================
> Andreas Steffen                         andreas.steffen at strongswan.org
> strongSwan - the Open Source VPN Solution!          www.strongswan.org
> Institute for Networked Solutions
> HSR University of Applied Sciences Rapperswil
> CH-8640 Rapperswil (Switzerland)
> ===========================================================[INS-HSR]==
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.strongswan.org/pipermail/users/attachments/20170307/0634dae5/attachment.html>