[strongSwan] First connection status

[T Cheung]

Hi Andreas,

Our system was typically built with minimum logs.  During debugging I
can manually turn
up log levels, but during boot I will have to rebuild the whole system
and I probably won't
get to that until next week.  Also our IPsec system is under a monitor
program, and I
just found the monitor was restarting the system and that probably
explains the "ipsec start"
output as it was shutting down.  I only heard about the initial start
issues, and not sure
if the monitor restaredt the system by mistake, or if the restart was
due to a real
issue.  I'll report back if I can gather more info from experiments or
from other folks
worked on the system.  And I'll get the logs if the issue is not
resolved next week.

Thanks,
Terry

On Wed, Jul 11, 2012 at 10:24 PM, Andreas Steffen
<andreas.steffen at strongswan.org> wrote:
> Hi Terry,
>
> could you send a log of your connection setup?
>
> Regards
>
> Andreas
>
> On 07/11/2012 10:41 PM, T Cheung wrote:
>> Hi,
>>
>> I have a net2net connection.  On the very first time one host starts up, and
>> tries a connection, the host that starts up seems to show incorrect
>> status info.  Output from "ipsec status" shows only the "ESTABLISHED"
>> line, but no "INSTALLED,  TUNNEL, ESP" or the "<net> ==== <net>"
>> line.  "ipsec status" on the other host has all 3 lines.  Is this a known
>> issue?  Is this fixable?
>>
>> Thanks,
>> Terry
>
> ======================================================================
> Andreas Steffen                         andreas.steffen at strongswan.org
> strongSwan - the Linux VPN Solution!                www.strongswan.org
> Institute for Internet Technologies and Applications
> University of Applied Sciences Rapperswil
> CH-8640 Rapperswil (Switzerland)
> ===========================================================[ITA-HSR]==
>
>