[strongSwan] By default strongswan inserts related routes to routing table 220!!
nima0102 at gmail.com
Fri Jun 10 19:03:24 CEST 2011
In my new project I have implemented StrongSwan and I could setup
IPsec tunnel to another linux (same strongswan version) via IKE2 and
also to Cisco via IKE1. after some investigation to strongswan I found
that by default strongswan inserts related routes to routing table
1- Is there any solution to change this number?that means, via
configuration I can set this number to another one (ex, 200)?
2- Where does StrongSwan insert related routes in IKE1?because I could
not find any routing table that new routes has been inserted!
Thanks in advance
More information about the Users