[strongSwan] revisiting problem with linux to VPN using network-manager-strongswan 1.4.5-2.1

Noel Kuntze noel.kuntze+strongswan-users-ml at thermi.consulting
Fri Jul 2 12:10:36 CEST 2021


Hello David,

strongSwan by default builds policy based tunnels, not route based tunnels.
Thus no interface is needed or created.
Read up on how IPsec works on the wiki to get an understanding for it.

GUI indicators are not inherently related to if any tunnel exists, or works.

Kind regards
Noel

Am 01.07.21 um 20:31 schrieb David H Durgee:
> I thought it might make sense to revisit this after the progress that has been made. It now appears that the connection is being established:
> 
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] authentication of 'durgeeenterprises.publicvm.com' with EAP successful
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] IKE_SA Durgee Enterprises, LLC[7] established between 192.168.1.114[dhdurgee]...108.31.28.59[durgeeenterprises.publicvm.com]
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] scheduling rekeying in 35705s
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] maximum IKE_SA lifetime 36305s
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] installing new virtual IP 10.10.10.1
>> Jun 29 11:21:34 Z560 avahi-daemon[750]: Registering new address record for 10.10.10.1 on wlp5s0.IPv4.
>> Jun 29 11:21:34 Z560 charon-nm: 11[CFG] selected proposal: ESP:AES_CBC_256/HMAC_SHA1_96/NO_EXT_SEQ
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] CHILD_SA Durgee Enterprises, LLC{4} established with SPIs c8cad4e5_i c3f2eec4_o and TS 10.10.10.1/32 === 0.0.0.0/0
>> Jun 29 11:21:34 Z560 charon-nm: 11[IKE] peer supports MOBIKE
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6991] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: VPN connection: (IP Config Get) reply received.
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6997] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: VPN plugin: state changed: started (4)
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.6997] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: VPN connection: (IP4 Config Get) reply received
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data: VPN Gateway: 108.31.28.59
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data: Tunnel Device: (null)
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data: IPv4 configuration:
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7003] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   Internal Address: 10.10.10.1
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   Internal Prefix: 32
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   Internal Point-to-Point Address: 10.10.10.1
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   Internal DNS: 8.8.8.8
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   Internal DNS: 8.8.4.4
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data:   DNS Domain: '(none)'
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7004] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: Data: No IPv6 configuration
>> Jun 29 11:21:34 Z560 NetworkManager[758]: <info> [1624980094.7013] vpn-connection[0x562fdb93c2f0,72e4370d-ecfb-4e33-8572-5cf04431abb9,"Durgee Enterprises, LLC",0]: VPN connection: (IP Config Get) complete
> 
> Unfortunately I am not seeing a tunnel interface being created and routing added:
> 
>> enp6s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
>>         ether b8:70:f4:2c:6b:9f  txqueuelen 1000  (Ethernet)
>>         RX packets 1143393  bytes 1164336056 (1.1 GB)
>>         RX errors 0  dropped 20  overruns 0  frame 0
>>         TX packets 912738  bytes 112966285 (112.9 MB)
>>         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>
>> lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
>>         inet 127.0.0.1  netmask 255.0.0.0
>>         inet6 ::1  prefixlen 128  scopeid 0x10<host>
>>         loop  txqueuelen 1000  (Local Loopback)
>>         RX packets 95404  bytes 9207887 (9.2 MB)
>>         RX errors 0  dropped 0  overruns 0  frame 0
>>         TX packets 95404  bytes 9207887 (9.2 MB)
>>         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>
>> wlp5s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
>>         inet 192.168.1.114  netmask 255.255.255.0  broadcast 192.168.1.255
>>         inet6 fe80::562f:7604:6d84:57ca  prefixlen 64  scopeid 0x20<link>
>>         ether ac:81:12:a4:5e:43  txqueuelen 1000  (Ethernet)
>>         RX packets 5644  bytes 4264877 (4.2 MB)
>>         RX errors 0  dropped 0  overruns 0  frame 62520
>>         TX packets 6377  bytes 1007195 (1.0 MB)
>>         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>         device interrupt 17
>>
>> dhdurgee at z560:~/Downloads$ route
>> Kernel IP routing table
>> Destination     Gateway         Genmask         Flags Metric Ref Use Iface
>> default         _gateway        0.0.0.0         UG    20600 0        0 wlp5s0
>> link-local      0.0.0.0         255.255.0.0     U     1000 0        0 wlp5s0
>> 192.168.1.0     0.0.0.0         255.255.255.0   U     600 0        0 wlp5s0
>> dhdurgee at z560:~/Downloads$
> 
> In case it is needed for reference, here is the ipsec.conf on the server side:
> 
>> config setup
>>   charondebug="ike 1, knl 1, cfg 1"
>>   uniqueids=no
>>
>> conn ikev2-vpn
>>   auto=add
>>   compress=no
>>   type=tunnel
>>   keyexchange=ikev2
>>   fragmentation=yes
>>   forceencaps=yes
>> ike=aes256-sha1-modp2048,aes256-sha1-modp1024,3des-sha1-modp1024!
>>   esp=aes256-sha1,3des-sha1!
>>   dpdaction=clear
>>   dpddelay=300s
>>   rekey=no
>>   left=%any
>>   leftid=@durgeeenterprises.publicvm.com
>>   leftcert=/etc/ipsec.d/certs/vpn-server-cert.pem
>>   leftsendcert=always
>>   leftsubnet=0.0.0.0/0
>>   right=%any
>>   rightid=%any
>>   rightauth=eap-mschapv2
>>   rightsourceip=10.10.10.0/24
>>   rightdns=8.8.8.8,8.8.4.4
>>   rightsendcert=never
>>   eap_identity=%identity
> 
> Here is the connection definition from /etc/NewtorkManager/system-connections:
> 
>> [connection]
>> id=Durgee Enterprises, LLC
>> uuid=72e4370d-ecfb-4e33-8572-5cf04431abb9
>> type=vpn
>> autoconnect=false
>> permissions=user:dhdurgee:;
>>
>> [vpn]
>> address=durgeeenterprises.publicvm.com
>> certificate=/home/dhdurgee/Downloads/vpn_root_certificate.pem
>> encap=no
>> ipcomp=no
>> method=eap
>> password-flags=1
>> proposal=no
>> user=dhdurgee
>> virtual=yes
>> service-type=org.freedesktop.NetworkManager.strongswan
>>
>> [ipv4]
>> dns-search=
>> method=auto
>>
>> [ipv6]
>> addr-gen-mode=stable-privacy
>> dns-search=
>> ip6-privacy=0
>> method=auto
>>
>> [proxy]
> 
> The listed connection was created via the GUI.  I have screenshots of the four pages from the GUI available for email as they violate size restrictions of posting here..
> 
> As the VPN connection is already working with android and windows systems I want to make no changes to the ipsec.conf on the server. All changes should be made to the linux connection.
> 
> I can only assume there are revisions to be made, hopefully via the GUI.  Obviously if the GUI cannot address what is needed I can edit the connection directly.
> 
> Alternatively, am I misunderstanding what I am seeing and the tunnel is actually being established?  I see only the WiFi icon on the bar at the bottom of the screen just as I do when opening the WiFi connection. With another VPN service, now discontinued, I showed a different icon indicating the secured tunnel was open.  This other discontinued service likewise created a tun interface and established a route via that interface.
> 
> If more information is required please let me know.
> 
> Dave
> 
> 

-------------- next part --------------
A non-text attachment was scrubbed...
Name: OpenPGP_signature
Type: application/pgp-signature
Size: 840 bytes
Desc: OpenPGP digital signature
URL: <http://lists.strongswan.org/pipermail/users/attachments/20210702/183c9555/attachment.sig>


More information about the Users mailing list