[strongSwan] Strongswan with Sonicwall GroupVPN and virtual IP

nate strongswan at linuxpowered.net
Wed Aug 25 20:25:21 CEST 2021

On 2021-08-24 12:09, nate wrote:
> Hello!

Only crickets on this list I guess.

Fortunately I was able to figure out the problem, if I remove this
line from the config it works:


I guess I got confused by the man page doc

  modeconfig = push | pull
               defines which mode is used to assign a virtual IP.
Accepted values are push and pull (the default).  Push mode is currently 
supported with IKEv2.  The setting must be the same on both sides.

Since I am using IKEv1 I assumed incorrectly that it needed push.


More information about the Users mailing list