[strongSwan] IPSec Tunnel Up, But No Traffic
Noel Kuntze
noel at familie-kuntze.de
Tue Jul 29 22:56:24 CEST 2014
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA256
Hello Joe,
Are there any rules in *nat POSTROUTING? If so, please check those, as they can stop encrypted traffic from being sent to the correct destination.
Furthermore, check if you permit esp packets.
Regards,
Noel Kuntze
GPG Key id: 0x63EC6658
Fingerprint: 23CA BB60 2146 05E7 7278 6592 3839 298F 63EC 6658
Am 29.07.2014 um 22:46 schrieb Joe Ryan:
> Thank you for the response Noel, The bytes_o goes up when I ping from either of the hosts, but the bytes_i remains at zero for both. Both machines have an iptables firewall, and when I do iptables -L -n I see that StrongSwan has inserted several rules (as shown below) matching ipsec traffic. From your response it seems I should open additional protocols, sources and destinations, but I'm not sure what I should open to get traffic, but stay secure. Any suggestions would be great.
>
> Thank you,
> Joe
>
> Chain INPUT (policy ACCEPT)
> target prot opt source destination
> ACCEPT all -- 10.128.0.0/16 192.168.250.0/24 policy match dir in pol ipsec reqid 1 proto 50
>
> Chain FORWARD (policy ACCEPT)
> target prot opt source destination
> ACCEPT all -- 10.128.0.0/16 192.168.250.0/24 policy match dir in pol ipsec reqid 1 proto 50
> ACCEPT all -- 192.168.250.0/24 10.128.0.0/16 policy match dir out pol ipsec reqid 1 proto 50
>
> Chain OUTPUT (policy ACCEPT)
> target prot opt source destination
> ACCEPT all -- 192.168.250.0/24 10.128.0.0/16 policy match dir out pol ipsec reqid 1 proto 50
>
> On 2014-07-29 13:27, Noel Kuntze wrote:
> Hello Jose,
>
> Is there a firewall active on either of the host? Do the traffic
> counters, which are shown in the output of "ipsec statusall",
> increment?
>
> Regards,
> Noel Kuntze
>
> GPG Key id: 0x63EC6658
> Fingerprint: 23CA BB60 2146 05E7 7278 6592 3839 298F 63EC 6658
> Am 29.07.2014 um 22:24 schrieb Joe Ryan:
> >>> Hello Everyone,
> >>>
> >>> I have a DigitalOcean VPS running Ubuntu 12.04 that I want to connect to with a BeagleBone running Debian so that I can access all of the devices on the same subnet as the BeagleBone, and not have to worry about an IT department opening ports. I have tried this with both StrongSwan 4.5.2 and 5.2.0 and have the same result, so I'm sure it's my configuration. After bringing up the the connection everything negotiates as expected, and the final line of ipsec status all is machinetun{1}: 10.128.0.0/16 === 192.168.250.0/24 where machinetun is the connection 10.128.0.0/16 is a private network on DigitalOcean and the 192.168.250.0/24 is a private network on my machine. My logs show the CHILD_SA being established and rekeyed as expected, with keep alive packets going out frequently, and nothing to suggest a problem.
> >>>
> >>> At this point I would hope that I would be able to ping the gateway on my machine, 192.168.250.60 from the DigitalOcean VPS private IP address using one of the following:
> >>>
> >>> #ping the BeagleBone gateway from DO
> >>> ping 192.168.250.60
> >>> #ping the BeagleBone gateway with an interface on the DO private network
> >>> ping -I 10.128.120.160 192.168.250.60
> >>>
> >>> But get no results in this direction or the reverse.
> >>>
> >>> I also have net.ipv4.ip_forward 1 on both machines.
> >>>
> >>> My configurations are below, and I hope someone might have a good idea what direction I can look to in to figure out what I've done wrong.
> >>>
> >>> # BeagleBone Conf
> >>> config setup
> >>> strictcrlpolicy=no
> >>> charondebug=1
> >>> conn %default
> >>> ikelifetime=60m
> >>> keylife=20m
> >>> rekeymargin=3m
> >>> keyingtries=%forever
> >>> keyexchange=ikev2
> >>> left=%any
> >>> leftcert=beagleCert.der
> >>> leftid=beagle at hostname.com
> >>> lefthostaccess=yes
> >>> leftfirewall=yes
> >>>
> >>> conn machinetun
> >>> leftsourceip=%config
> >>> leftsubnet=192.168.250.0/24
> >>> right=hostname.com
> >>> rightid=@hostname.com
> >>> rightsubnet=10.128.0.0/16
> >>> auto=start
> >>>
> >>> # DigitalOcean Conf
> >>> config setup
> >>> strictcrlpolicy=no
> >>> conn %default
> >>> ikelifetime=60m
> >>> keylife=20m
> >>> rekeymargin=3m
> >>> keyingtries=1
> >>> keyexchange=ikev2
> >>> left=%any
> >>> leftcert=svCert.der
> >>> leftid=@hostname.com
> >>> lefthostaccess=yes
> >>> leftfirewall=yes
> >>>
> >>> conn machinetun
> >>> leftsubnet=10.128.0.0/16
> >>> right=%any
> >>> rightsubnet=192.168.250.0/24
> >>> rightid=beagle at hostname.com
> >>> rightsourceip=10.128.0.50
> >>> auto=add
> >>>
> >>> Thank you,
> >>> Joe
> >>> _______________________________________________
> >>> Users mailing list
> >>> Users at lists.strongswan.org
> >>> https://lists.strongswan.org/mailman/listinfo/users
>
>>
>> _______________________________________________
>> Users mailing list
>> Users at lists.strongswan.org
>> https://lists.strongswan.org/mailman/listinfo/users
>
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2
Comment: Using GnuPG with Thunderbird - http://www.enigmail.net/
iQIcBAEBCAAGBQJT2Ap4AAoJEDg5KY9j7GZYOJIP/1lNi66ZHkZaGohX5yPu5Luf
8A/wHoU/hakxrYpKBfwD2Yik3PYEqGb2gU8KoQbZCwp3bqNg5ctwcI8gL1Hy57bM
S9wb3ppHXbUNAkG+QGtPYZCLyQe8celiTx+U/izRFYMJcW+smAJ61vdGDyL5lF12
AFTVBawB+9Knyn2mWgncZ9ylZJeETcEttBJwgLueMv4P7AF2aOEsj3D5ueWpLsTT
TnjdOuoQoVjlNPoo2Ck5QxMHD827wdMk+80dEYQWrfHLS41gH0td+mgeQgzrN6Ar
70wmHjxzhATalmuZi4DC4U1Ls40ngeReXNgSCehEZoiXRy+/h3dvS0Fcc98nQ9le
+MlKHUV69g8dsEeSxY9XevmTh69zVbicN2XIKkW2QfRxypXIWoa05EBAe9FgUAJS
3KWXMOc0drerqSY/trNwg537dQVv2HTf/8IolrQgInCIzCFMeKgPR1Js0b6x908+
s4ri/uOIoRPZgsqJIp49wYPcrXEKc12ToFjljs3RBrTYdkGCWm4Ecav+0uI3U3Mx
2bympmygxX04KNXyD5JFbl90My5mVuwIThBg50fj8QzLrN5pxeUOzjCJWIkgRX+D
jAtjRwnzlfMnifgFsEBJeZJHSJgB4GJonLiEhNY0PStF0sql59UplPwb2Ad9CvTQ
a0sUWNGw+IG6dXFsUlLa
=B0YR
-----END PGP SIGNATURE-----
More information about the Users
mailing list