[strongSwan] issue found in strongswan-5.0.1dr4

[Martin Willi]

Hi Robert,

> When assigning IPv4 and IPv6 addresses for the single tunnel, client
> gets both VPN addresses, IPv4 routing is working fine, but there is no
> IPv6 routing/traffic over the tunnel.

I think this bug has been fixed with [1], the release candidate at [2]
should support dual IPv4/IPv6 selectors when requesting multiple IPs. A
corresponding test case is available at [3].

Regards
Martin

[1]http://git.strongswan.org/?p=strongswan.git;a=commitdiff;h=7ee37114
[2]http://download.strongswan.org/strongswan-5.0.1rc1.tar.bz2
[3]http://www.strongswan.org/uml/testresults5rc/ikev2/ip-two-pools-v4v6/