[strongSwan] Listing multiple IP addresses on the rightsubnet

Mohammady Mahdy mohammady.mahdy at getmo.com
Tue Mar 27 07:07:23 CEST 2012

Thanks for your reply.

Is there a known workaround around this?

Thanks & Best Regards,

-----Original Message-----
From: Andreas Steffen [mailto:andreas.steffen at strongswan.org] 
Sent: Monday, March 26, 2012 6:26 PM
To: Mohammady Mahdy
Cc: users at lists.strongswan.org
Subject: Re: [strongSwan] Listing multiple IP addresses on the rightsubnet

Hello Mahdy,

this notation works with IKEv2 only.



On 26.03.2012 10:53, Mohammady Mahdy wrote:
> Hi,
> I've been given multiple IP addresses that are too diverse to fit in
> a reasonable sized subnet. I am using the same installation as a 
> lan-to-lan gateway for multiple connections, and I don't wish to use
> an oversized subnet that might make life harder  in adding newer
> subnets in the future.
> Is there a way to put a list of IP addresses in the rightsubnet?
> I tried something like:
> It starts up fine but the first address only is recognized.
> Any ideas about the recommended configuration style to use?
> Thanks & Best Regards,
> Mahdy

Andreas Steffen                         andreas.steffen at strongswan.org
strongSwan - the Linux VPN Solution!                www.strongswan.org
Institute for Internet Technologies and Applications
University of Applied Sciences Rapperswil
CH-8640 Rapperswil (Switzerland)

More information about the Users mailing list