[strongSwan] V5 RC "no XAuth method found" error

[Andreas Steffen]

Hi,

did you enable XAUTH by building

  ./configure ... --enable-xauth-generic

If you are using XAUTH then modeconfig=push doesn't make much sense.

Regards

Andreas

On 06/24/2012 11:49 AM, Igor wrote:
> Trying to use cool V5 Strongswan to replace V4.3, but it breaks
> working Apple iOS VPN server config.
> Complaint error like: Jun 24 09:34:41 13[CFG] no XAuth method found,
> what's wrong with my config?
> 
> Thanks.
> 
> ipsec.secrets
> 
> <serverIP> %any : PSK xxx
> test : XAUTH "test"
> 
> ipsec.conf
> 
> conn apple
>         type=tunnel
>         auto=start
>         installpolicy=yes
>         authby=xauthpsk
>         xauth=server
>         modeconfig=push
>         left=%defaultroute
>         leftsubnet=0.0.0.0/0
>         right=%any
> 
> 
> Bests,
> -Igor

======================================================================
Andreas Steffen                         andreas.steffen at strongswan.org
strongSwan - the Linux VPN Solution!                www.strongswan.org
Institute for Internet Technologies and Applications
University of Applied Sciences Rapperswil
CH-8640 Rapperswil (Switzerland)
===========================================================[ITA-HSR]==