[strongSwan] ikev1 without specifying rightid
Mark.Marwil at gdc4s.com
Tue Jun 29 01:30:38 CEST 2010
I am using Strongswan version 4.3.6 setup according to the example
ikev1/nat-before-esp. This configuration works for me if I specifiy the
full DN for the rightid parameter. When I take the rightid out, the
I would like to find out if it is possible to just specify the peers IP
address without specifying the DN. Is there a way to tell Pluto that it
should trust the peer even if it does not know the DN?
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Users