[strongSwan-dev] ikev1 without specifying rightid

[Marwil, Mark-P63354]

I am using Strongswan version 4.3.6 setup according to the example
ikev1/nat-before-esp.  This configuration works for me if I specifiy the
full DN for the rightid parameter.  When I take the rightid out, the
connection fails.  

I would like to find out if it is possible to just specify the peers IP
address without specifying the DN.  Is there a way to tell Pluto that it
should trust the peer even if it does not know the DN?

Thank you,

Mark Marwil

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.strongswan.org/pipermail/dev/attachments/20100628/9da04986/attachment.html>