<div dir="ltr">Hi,<div><br></div><div>As I understood from the docs, if one uses "uniqueids=keep" in the "config setup" section of the ipsec.conf file, strongswan should send the INIT_CONTACT message with the first IKE_AUTH request sent to the peer.</div><div><br></div><div>But, I also see that if I use "rightid=%any" in the same ipsec.conf file in the "conn" section, this INIT_CONTACT is NOT being sent with IKE_AUTH request. It's only if I use a more specific selector in the rightid parameter that INIT_CONTACT is being sent with IKE_AUTH request when bringing the connection up.</div><div><br></div><div>What is the reason for this ? Is it the expected behaviour ?</div><div><br></div><div>Thanks in advance.</div><div><br></div><div>Regards,</div><div>Marko.</div></div>